Tools
and supplies:
 Framing square
Levels
Twist-Lok drill and driver system
Safety
goggles
Hacksaw with a fine-toothed blade for cutting metal
Power
Miter Saw
Carpenter's
pencil
Power
drill
Assorted
drill bits
Assorted
driver bits
Corrosion-resistant decking screws
Wood clamps
Drill press
Oscillating spindle sander
Hammer
Measuring tape
Plate joiner
Bar clamps
Random orbital sander
Router
3/8" roundover bit
Hammer
Natural bristle brush (1" - 2")
Natural bristle small touchup brush
Small plastic container
Materials:
Cedar or redwood lumber (see cut list below for stock dimensions)
Duct tape
Screws
150-grit sandpaper
Axle caps (2x)
4" lawnmower wheels (2x)
1/2" washers (4x)
1/2" metal rod (wheel axle)
Metal utensil hooks (5x)
Titebond II weather resistant wood glue
Wood biscuits
Axle caps (2x)
4" lawnmower wheels (2x)
Thompson's® Water Seal® Advanced Tinted Wood Protector
Cut list:
Part name |
Quantity |
Dimensions |
| Front posts |
2 |
3-1/2” x 33-1/2” x 1-1/2” |
| Back posts |
2 |
3-1/2” x 32-1/2” x 1-1/2” |
| Runners |
2 |
2” x 43” x 1-1/2” |
| Top rails |
2 |
2” x 16” x 1-1/2” |
| Bottom rails |
2 |
3-1/2” x 13” x 1-1/2” |
| Bottom front/back |
2 |
3-1/2” x 29” x 1-1/2” |
| Shelf slats |
9 |
3-1/2” x 16” x 3/4” |
| Handle/towel rack |
1 |
3/4” dowel |
| Top front/back |
2 |
3-1/2” x 39” x 1-1/2” |
| Top rails |
5 |
3-1/2” x 14” x 1-1/2” |
| Support slats |
2 |
3-1/2” x 23” x 3/4” |
| Cutting
board |
1 |
13-1/2” x 19-1/2” |
| Paper towel holders |
2 |
1-1/2” x 5” x 1-1/2” |
| Condiment tray back |
1 |
5” x 16” – 3/4” |
| Condiment tray front |
1 |
3” x 16” – 3/4” |
| Condiment tray bottom |
1 |
3-3/4” x 16” – 3/4” |
| Condiment tray sides |
2 |
3” x 4-1/2” – 3/4” |
Note: This list is based on this specific project
and situation. Please adjust these items and instructions to your
particular needs.
|
